Dynojet model 100 upgraded to a 150 with soundproof booth and exhaust system ready to use and easy to move. We have had this unit for several years and it has been a great asset to us as we have built many motor packages over the years and could tell what parts and combinations really worked. However it is time for us to change direction and we would like to find the Dyno a new home. This unit has the following options installed, High Inertia Drum for testing bikes with more than 250 HP, High Torque Starter Motor, Extended Carriage for wheel bases up to 102" and the upgrade last done was the Dyno Ware EX+ Atmospheric Sensing Module and Winpep software 6.03 and can be upgraded to 7.5.1. We also have a Manometer so that you can monitor air pressure coming into the booth, fresh air AC and exhaust to keep balance. The soundproof booth measures 142" long 98" wide and 112" tall. It is this tall as it was originally built to mount the Dyno on the floor not in the floor as we did. So you can buy this total unit and not modify your building to install this total package as we have the ramp that goes with this package to mount the Dyno on the floor and roll or ride a bike up on the Dyno. The wooden floor you see inside will work both ways, either installed in a pit or you could simply build a riser and mount the Dyno on the floor and raise the platform. The door opening is 64 ¼" Tall and 47 ¾" Wide. You will need 13' of height to install this room as it is configured now; you could most likely install it in a 10' area with some creative ductwork for the air intake and exhaust. This unit can be upgraded to accept the Model 250i Load Control System that will allow you to tune fuel injected bikes and become a Dynojet tuning facility. This unit new with the booth was over $25,000.00 before the upgrades were installed. We will assist in directing the winning buyer on how to disassemble and move this unit. It is time consuming but not difficult. This unit is being sold as is and where is, removal is the responsibility of the buyer as it will be price less when you are installing it to know how it goes together.
Asking $6500.00 Please Feel Free To Call If You Have Any Questions
Or Email Us Here
mark@aardvarkcycle.com
